alignment

i finished three alignments one i did at work replaced  tie rods and a bent center bar also did one laser on the international and a string line on the freight liner. 

air breaks

i have worked  on quiet a few breaks and wheel seals since starting at cowden. i have learned there are all types of brakes and different types of slack adjusters and wheel seals . always pay attention.  

i was doing a standard break job on a pup trailer replacing the pads and the drum. when i took the pads off  i noticed  the pads were worn unevenly so i checked the s cam  and noticed the bushings were worn . i have learned that you always need to pay attention to what you are working on because it can indicate other problems.

06 yamaha 450and tc 450

replaced my stock clutch on my wr 450 with a recluse auto shifting clutch i also replaced my handle bars and put a scotts steering dampener on. changed the oil and cleaned the air filters in the wr and the tc 450. we repacked the wheel bearings and checked the brakes we also sealed a couple of leaks these project took a total of 18 hours. i have a total of 59 hours this month and a total of 302 hours for the quarter.   

work source scholarship

i have spent a considerable amount of time working on getting this scholarship  i have done a lot of research and went and interviewed potential employers. i spent  a total of  16 hours  on this project.   

1985 chevy mini wini engine swap

 installed  air bags on the rear axel we jacked up rear of the motor home took out bump stops we installed brackets  and air bags  ran air lines to air compressor and wired the air compressor. we also spent a good amount of time sealing the roof of the motor home in all this project took a total of 15 hours on thees projects. 

toyota forklift

installed water pump new thermostat filled with coolant also hooked up exhaust and installed oil dipstick finished the project this took a total of 10 hours.